SANY signs its Kenyan dealer for a broader market

spray dryer design

Time:2020-12-24 Author:admin

spray dryer design

It is transferred to the centrifugal atomizer through the peristaltic pump, and the material to be dried is dispersed into very fine mist-like particles. In contact with the hot air, the evaporation area of the water is increased, and the drying process is accelerated. The water vaporizes instantly. Most of the water is removed and separated by a cyclone separator to obtain a dry product.The product quality can be well controlled by controlling the concentration of the material liquid, the amount of feed, the temperature of the inlet air, the temperature of the outlet air, and the air supply rate. The process has strong continuity, high thermal efficiency, less waste gas and wastewater, and the drying chamber has a certain negative Low dust in the workshop, high production efficiency and few operators.This method can directly dry the solution and emulsion into powder or granular products, and can omit the steps of evaporation and crushing. The product has high purity and concentrated particle size distribution.

20200520104549_8630.jpg

How to use the centrifugal spray dryer: 1. Prepare before you start Before starting the spray dryer, please prepare the items needed for the experiment.

20200520105441_3562.jpg

Note: To ensure product quality, the equipment must be thoroughly cleaned before use, and whether it is disinfected according to product requirements.

      2. Turn on the power of the spray dryer → → turn on the fan, turn on the heater, and set the inlet air temperature → → when the heating temperature reaches the set temperature, start the peristaltic pump to start feeding → → start spray drying

20200520105257_7013.jpg

3. Preparations before shutting down the spray dryer: when the feeding liquid is about to be completed, replace the empty powder collector, add fresh water to the feeding bucket, reduce the amount of water entering the atomizer, and keep the outlet temperature unchanged (this Very important otherwise, the moisture content of the medicinal powder remaining in the drying chamber will change); in order to initially clean the atomization plate and feed tube, please rinse with water for about 5 to 10 minutes; then you can turn it off.

20200520105548_0585.jpg

Shutdown procedure: turn off the heater → → then turn off the feed pump → → wait until the temperature drops below 60 ℃, then turn off the induced draft fan → → finally turn off the power.

4. Equipment cleaning After turning off the power of the equipment, open the door of the drying chamber to clean the walls and bottom of the drying chamber and the powder accumulated near the centrifugal atomizer, and then clean the equipment.

20200520105646_1046.jpg

Experienced, Knowledgable, Trustworthy

Quick and helpful reply within 24 hours;
Tailored solutions provided for your project;
One-stop purchasing service.